Seafloor spreading

Incipient spreading
Plates in the crust of the earth, according to the plate tectonics theory
In the general case, sea floor spreading starts as a rift in a continental land mass, similar to the Red Sea-East Africa Rift System today. The process starts with heating at the base of the continental crust which causes it to become more plastic and less dense. Because less dense objects rise in relation to denser objects, the area being heated becomes a broad dome (see isostasy). As the crust bows upward, fractures occur that gradually grow into rifts. The typical rift system consists of three rift arms at approximately 120 degree angles. These areas are named triple junctions and can be found in several places across the world today. The separated margins of the continents evolve to form passive margins. Hess' theory was that new seafloor is formed when magma is forced upward toward the surface at a mid-ocean ridge.
Early spreading
If spreading continues past the incipient stage described above, two of the rift arms will open while the third arm stops opening and becomes a 'failed rift'. As the two active rifts continue to open, eventually the continental crust is attenuated as far as it will stretch. At this point basaltic oceanic crust begins to form between the separating continental fragments. When one of the rifts opens into the existing ocean, the rift system is flooded with seawater and becomes a new sea. The Red Sea is an example of a new arm of the sea. The East African rift was thought to be a "failed" arm that was opening somewhat more slowly than the other two arms, but in 2005 the Ethiopian Afar Geophysical Lithospheric Experiment reported that in the Afar region last September, a 60 km fissure opened as wide as eight meters. During this period of initial flooding the new sea is sensitive to changes in climate and eustasy. As a result the new sea will evaporate (partially or completely) several times before the elevation of the rift valley has been lowered to the point that the sea becomes stable. During this period of evaporation large evaporite deposits will be made in the rift valley. Later these deposits have the potential to become hydrocarbon seals and are of particular interest to petroleum geologists.
Sea floor spreading can stop during the process, but if it continues to the point that the continent is completely severed, then a new ocean basin is created. The Red Sea has not yet completely split Arabia from Africa, but a similar feature can be found on the other side of Africa that has broken completely free. South America once fit into the area of the Niger Delta. The Niger River has formed in the failed rift arm of the triple junction.
Continued spreading and subduction
Spreading at a mid-ocean ridge
The new oceanic crust is quite hot relative to old oceanic crust, so the new oceanic basin is shallower than older oceanic basins. If the diameter of the earth remains relatively constant despite the production of new crust, a mechanism must exist by which crust is also destroyed. The destruction of oceanic crust occurs at subduction zones where oceanic crust is forced under either continental crust or oceanic crust. Today, the Atlantic basin is actively spreading at the Mid-Atlantic Ridge. Only a small portion of the oceanic crust produced in the Atlantic is subducted. However, the plates making up the Pacific Ocean are experiencing subduction along many of their boundaries which causes the volcanic activity in what has been termed the Ring of Fire of the Pacific Ocean. The Pacific is also home to one of the world's most active spreading centres (the East Pacific Rise (EPR)) with spreading rates of up to 13 cm/yr. The Mid-Atlantic Ridge is a "textbook" slow spreading centre while the EPR is used as an example of fast spreading. The differences in spreading rates affect not only the geometries of the ridges but also the geochemistry of the basalts that are produced. Since the new oceanic basins are shallower than the old oceanic basins, the total capacity of the world's ocean basins decreases during times of active sea floor spreading. During the opening of the Atlantic Ocean, sea level was so high that a Western Interior Seaway formed across North America from the Gulf of Mexico to the Arctic Ocean.
Debate and search for mechanism
At the Mid-Atlantic Ridge (and other places), material from the upper mantle rises through the faults between oceanic plates to form new crust as the plates move away from each other, a phenomenon first observed as continental drift. When Alfred Wegener first presented a hypothesis of continental drift in 1912, conservative geologists, especially in North America, demanded to know where the motive force could possibly lie. Wegener suggested that the continents ploughed through the ocean crust.
Since then, it has been shown that the motion of the continents is linked to seafloor spreading. In the 1960s, the past record of geomagnetic reversals was noticed by observing the magnetic stripe "anomalies" on the ocean floor. This results in broadly evident "stripes" from which the past magnetic field polarity can be inferred by looking at the data gathered from simply towing a magnetometer on the sea surface or from an aircraft. The stripes on one side of the mid-ocean ridge were the mirror image of those on the other side. The seafloor must have originated on the Earth's great fiery welts, like the mid-Atlantic Ridge and the East Pacific Rise.
The driver for seafloor spreading in plates with active margins the weight of the cool, dense, subducting slabs that pull them along. The magmatism at the ridge is considered to be "passive upwelling", which is caused by the plates being pulled apart under the weight of their own slabs. This can be thought of as analogous to a rug on a table with little friction: when part of the rug is off of the table, its weight pulls the rest of the rug down with it.
See also
Divergent boundary
Mid-ocean ridge
Morley-Vine-Matthews hypothesis
References
^ H. H. Hess, "History Of Ocean Basins" (November 1, 1962). IN: Petrologic studies: a volume in honor of A. F. Buddington. A. E. J. Engel, Harold L. James, and B. F. Leonard, editors. [New York?]: Geological Society of America, 1962. pp. 599-620.
^ Patriat, Philippe (1984). "Indiaurasia collision chronology has implications for crustal shortening and driving mechanism of plates". Nature 311: 615. doi:10.1038/311615a0. 
External links
Animation of a mid-ocean ridge
v  d  e
Physical oceanography
Landforms
Abyssal fan  Abyssal plain  Atoll  Bathymetric chart  Cold seep  Continental shelf  Continental margin  Contourite  Hydrography  Guyot  Oceanic basin  Oceanic plateau  Oceanic trench  Passive margin  Seabed  Seamount  Submarine canyon  Coastal geography  More...
Plate tectonics
Black smokers  Convergent boundary  Divergent boundary  Fracture zone  Hydrothermal vents  Marine geology  Mid-ocean ridge  Mohorovii discontinuity  Morleyineatthews hypothesis  Oceanic crust  Outer trench swell  Ridge-push  Seafloor spreading  Slab window  Subduction  Transform fault  Volcanic arc  More...
Circulation
Baroclinity  Boundary current  Coriolis effect  Downwelling  Eddy  Ekman layer  Ekman spiral  Ekman transport  El Nio-Southern Oscillation  Geostrophic current  Gulf Stream  Halothermal circulation  Humboldt Current  Hydrothermal circulation  Global circulation model  Langmuir circulation  Longshore drift  Loop Current  Maelstrom  Ocean current  Ocean dynamics  Oceanic gyre  Thermohaline circulation  Shutdown of thermohaline circulation  Subsurface currents  Sverdrup balance  Whirlpool  Upwelling  GLODAP  MOM  WOCE  More...
Waves
Airy wave theory  Ballantine Scale  Boussinesq approximation  Breaking wave  Clapotis  Cnoidal wave  Cross sea  Dispersion  Infragravity waves  Edge wave  Equatorial waves  Fetch  Freak wave  Gravity wave  Internal gravity waves  Internal wave  Kelvin wave  Luke's variational principle  Mild-slope equation  Rogue wave  Rossby wave  Rossby-gravity waves  Sea state  Seiche  Significant wave height  Sneaker wave  Soliton  Stokes drift  Surf wave  Swells  Tsunami  Undertow  Ursell number  Wave base  Wave height  Wave power  Wave shoaling  Wave radar  Wave turbulence  Waves and shallow water  Shallow water equations  Wind wave  Wind wave model  More...
Tides
Amphidromic point  Earth tide  Head of tide  Internal tide  Lunitidal interval  Perigean spring tide  Rip current  Rule of twelfths  Slack water  Spring/neap tide  Tidal bore  Tidal force  Tidal power  Tidal race  Tidal range  Tidal resonance  Tide  Tide gauge  Tideline  More...
Sea level
Current sea level rise  Future sea level  Sea-level curve  DART  GLOSS  NOOS  OSTM  WGS
Acoustics
Ocean acoustic tomography  Sofar bomb  SOFAR channel  Underwater acoustics  Hydroacoustics
Other
Alvin  Argo  Benthic lander  Deep ocean water  Deep sea  Littoral zone  Marginal sea  Mooring  Ocean energy  Ocean observations  Ocean reanalysis  Ocean surface topography  Ocean thermal energy conversion  Oceanic zone  Pelagic zone  Sea surface microlayer  Sea surface temperature  Seawater  Science On a Sphere  Thermocline  Underwater glider  Water column  World Ocean Atlas  NODC  More...
Categories: Geological processes | Plate tectonicsHidden categories: Articles needing additional references from March 2008 | All articles needing additional references