Faucet Replacement in 4 Easy Steps

If you're looking for a way to improve the aesthetics and functionality of your home, but don't want to undergo hassles and incur large costs, a faucet replacement is the thing for you. Just replace an old faucet with a new one and be amazed with how big a difference you can make. Other than that, no more irritating noise that a dripping and leaky faucet generates.

The first step in faucet replacement is looking for the right faucet. Although there are many types, styles and combinations of faucets in the market today, the first thing you have to be concerned about is whether the faucet you choose will fit into the old sink.

Also keep in mind that for supply connections, there are two possibilities. Your faucet could either have flexible copper supply inlets found in the center of the unit, or the inlets could be located under the hot and cold handles.

Before anything else, shut off the main water supply. You can do this by shutting off the control valve found under the sink. It is also recommended that you prepare all the necessary materials beforehand, and don't forget to prepare some penetrating oil in case the mounting nuts are hard to remove, and are stuck. It is also best if you have someone around to help you in handing out the tools as you work. Also, don't forget to plug the drain with rags so that small parts like screws and bolts cannot go down the drain.

- Remove the old fixture

First, remove the nuts that attach the hose to the faucet body and the spray head to the sink (if you're using a faucet with sprayer). Remove supply lines and set them aside. Remove the mounting nuts that hold the faucet body to the sink. Use your wrench for this. If mounting nuts are difficult to pry loose, use penetrating oil.

Once faucet is removed, clean the sink from putty and mineral deposits by scraping it off (you can use a steel wool).

- Attach new faucet to the sink

You can use a rope of plumber's putty or install a gasket either to the sink or to the faucet. Put the new faucet in place, making sure that it is parallel to the backsplash. Move under the sink and ask someone to hold the faucet for you while you work. Screw on a washer and mounting nut on every inlet, and tighten using basin wrench.

- Connect supply lines

Cover inlet threads with Teflon tape or with pipe joint compound. Afterwards, twist the supply line nut on the inlet and start tightening it, by hand at first, and then by wrench. Connect shutoff valve to the other end of supply line using the same procedure.

If flexible copper inlets are used for water supply, the same applies, except that you have to ascertain that no copper tubes are twisted. The faucet could become destroyed if copper tubes are twisted.

- Connect and adjust the pop-up drain assembly

If installing a bathroom faucet, insert a ball rod into the opening located in the drain body. Secure it using the nut provided. Slip the rod through the clevis strap. Afterwards, secure it using spring clips. Lower the rod through the hole near the rear of the faucet spout, up until the holes at the upper end of clevis strap. Tighten the thumbscrew and adjust the rods.

And those are the steps to faucet replacement. It may look hard, but once you're at it, everything will become much easier. So, give it a try!