Ntp Server - Why the Need for a Dedicated Time Server

Just as your computer is only as good as the software it is running, a time server is only as useful as the timing source it uses. Time servers are similar to other servers in that they are located on a network but the primary function of a time server is to supply timing information rather than storing or routing data.

For computers a time stamp is the only point of a reference a computer can use to establish a sequence of events. Timestamps are used in everything from sending an email to debugging a system and ensuring your network is secure.

Nearly all time servers rely on NTP (Network Time Protocol) to synchronise devices once a timing source is selected Whilst it is not the only protocol designed for synchronisation it is by far the most widely used, primarily because it has been under constant development since its inception nearly three decades ago.

A time server works by receiving a time reference from an authoritative source, normally a UTC time source. UTC (Coordinated Universal Time) is an International timescale based on the time told by atomic clocks.

Unfortunately many administrators opt to use an Internet timing source to run their time server with. However, several studies of Internet timing references discovered that nearly two thirds were inaccurate by over several seconds (almost an eternity in the world of NTP) and those that weren't were often too far away from a client to provide reliable accuracy.

Probably the most accurate and widely used method of retrieving a reliable time reference is to use a dedicated GPS Time Server, many national physics laboratories also broadcast the time told by their atomic clocks via long wave radio. These signals can be received by a time server if it is equipped with a radio receiver although not every country broadcasts one and the transmissions are susceptible to interference and local topography.

Once this secure UTC time reference is received the time server can then distribute the time across the network. The timestamp itself is represented as a single ascending number. The number is the amount of seconds from a prime epoch (start number) normally 01 January 1900. The time server checks the system clocks on its clients and advances or retracts the time until all machines on the network are synchronised.